About the Masks

Is the three-layer mask pattern intended as a stand-alone mask, or only to cover an N95 or other medical-grade mask?
It is intended as a stand-alone mask, but can be used as a cover for a manufactured mask if a healthcare provider chooses to do so.  We also make a mask cov...
Fri, Apr 3, 2020 at 10:47 AM
Is the pocket mask with no Pellon preferred for everyday use?
The best mask for everyday use is the three-layer mask, because it has a middle layer of interfacing that can be thrown in the washer and dryer.  However, n...
Fri, Apr 3, 2020 at 10:49 AM
What is the pocket for in the pocket mask?
The pocket is a feature that is sometimes requested by organizations.  It is up to the organizations and the users what they decide to put in the pocket (us...
Fri, Apr 3, 2020 at 10:51 AM
Why did we choose our preferred mask pattern out of all the possible ones?
We believe the created-for-crisis three-layer mask is superior to other designs for several reasons.   One key reason is that the three-layer mask uses ...
Sat, Apr 4, 2020 at 7:23 PM
How do these masks compare to N95 respirators or surgical masks?
While these masks have utility in daily use, it is important to remember that homemade masks crafted from found materials are not as effective as medical-gr...
Mon, Apr 6, 2020 at 5:12 PM
What is the mask cover? Does it affect the effectiveness of an N95 respirator?
Our mask cover is designed to fit over an N95 respirator, and will not interfere with the seal of the respirator if worn properly.  The N95 should still be ...
Mon, Apr 6, 2020 at 5:36 PM
Has any research or testing gone into the designs of these masks?
These are not surgical masks or a form of approved medical-grade PPE.  They have not been formally tested or approved by any relevant institution.  Given th...
Mon, Apr 6, 2020 at 5:42 PM
Can I just get a few masks? Do I need to be an organization?
If you'd like just a few masks, the easiest way to go about it would be to join the Facebook group of your local team and make a request there. You'...
Mon, Apr 6, 2020 at 8:08 PM